HY-E615 Addition Curing Platinum Silicone Rubber 15 Shore A for Food and Craft Molds

Summary: HY-E615 is a 15 Shore A addition curing platinum silicone for food moulds, candle moulds and fine craft pieces.

Overview

A soft platinum cure rubber. It follows undercuts instead of forcing the casting out, so fine relief and thin lettering survive demoulding.

Specifications

HY-E615, 15 Shore A, parts A and B, mixed 1:1 or 10:1, translucent, -60C to 200C, packed in 1/5/20/25/200kg.

Features

Low shrinkage, high elongation, good tear strength at thin sections, steady hardness between batches. The addition cure emits no by-products, so the master stays clean.

How to Use

Stir each part, weigh at the ratio given, mix for two to three minutes, then degas. Pour slowly from one corner and cure at room temperature or with gentle heat.

Applications

Chocolate and candy moulds, cake decorating moulds, candle and soap moulds, resin craft pieces and small figurines with fine detail.

Buyer Benefits

Fine detail is reproduced, edges stay intact, trials begin at 10kg.

Compliance

Grade documents list ISO9001, RoHS, REACH, FDA, UL and CE.

Customization

Available in any hardness from 10 to 50 Shore A. Colour, ratio and packaging are set per order.

Quality Control

Batches are retained for traceability. A pre-production sample is cast against the buyer's master, and each order is inspected before dispatch.

FAQ

MOQ is 10kg. Set time depends on temperature and section thickness. Samples for mould trials are available.